| |
EASY ROTA WORM SEPARATOR Product Line
The EASY ROTA is ideal for customers that go on to make large quantities for Vermicast, ie. dairy farms, small crop farmers, food factories, or even your own operation etc. and want a fast, low labor efficient cast and worm separator, of a high degree of efficiency.
The EASY ROTA has a 12 month factory warranty.
EASY ROTA 2000
Commercial Compost Worm Separator
Another quality Vital Earth Company Product [Patent Pending]
|
|
At last a commercial worm separator that meets the demands of the industry, providing separation into two trays, one for worm and one for cast.
|
Features
|
Please note this is a heavy duty commercial product |
- Easy feed shoot that you can shovel to, or tip lug trays, plus pass empty trays to.
- Feed rate of cast is a continuous 20 to 30 lbs a minute [ 1200 to 1800 lbs an hour ]
- Spike configuration greatly reduces balling and clumps in cast tray.
- Spikes also break up tight cast leaving a fine sorted cast.
- Spikes hook up worm in first few seconds, no stress on worm.
- Multiple back angled spikes ensure near 100% hook up.
- One man operated. Only two collection points, one for cast, one for worm.
- Heavy duty capacitor start motor 240v A.C. with earth leakage protection.
- Control switches for operator at both ends, height adjustment at feed shoot end.
- Flexible drive to motor from gearbox. Residual worm cast in less than 1%
- No worm death, or loss from stress, falling, or light. Worm recovered inside drum.
- Epoxy coated drum, and frame, with yellow safety rail on drive side.
- Pneumatic rear wheels, and swivel up front legs suited to paddock transportation.
- Tow bar [and large dolly wheel] Tow with tractor, car, or ride on mower.
- Worm recovery trays, on a location slide, 3 supplied trays pull out for easy access.
- Can be used on dry or wet cast, or cast full of sticks, stones, and leaves, all sorted.
- Self adjusting double roller drive with 4 heavy duty solid rubber wheels.
- Powerful motor, and right angle heavy duty gear box, 4 heavy duty bearing blocks.
- Dimensions: Drum 1.5 metres long, by 1 metre diameter. (5' x 3.3') Weight 540lbs
- Quick swivel front legs, and screw adjustable from both ends via dolly wheel.
At last a purpose built worm separator that meets the demands of the industry, providing separation into two trays, one for worm and one for cast.
|
Features
|
Please note this unit is built to commercial standards |
- Easy feed shoot that you can shovel to, or tip lug trays.
- Feed rate of cast is a continuous 6 to 10 lbs a minute [ 400 to 650 lbs an hour ]
- Spike configuration greatly reduces balling and clumps in cast tray.
- Spikes also break up tight cast leaving a fine sorted cast.
- Spikes hook up worm in first few seconds, no stress on worm.
- Multiple back angled spikes ensure near 100% hook up.
- One man operated. Only two trays needed, one for cast, one for worm.
- Easily driven hand crank at feed shoot end.
- Heavy duty bearing blocks on crank handle.
- Residual worm cast in less than 1%.
- No worm death, or loss from stress, falling, or light. Worm recovered in drum.
- Fully galvanized frame and epoxy coated drum.
- Permanent solid rubber wheels suited to paddock transportation.
- Folding handles for wheels barrow like transportation.
- Worm recovery trays, on a location slide, 2 supplied trays pull out for easy access.
- Can be used on dry or wet cast.
- Self adjusting double roller drive with 4 heavy duty solid rubber wheels.
- Drum simply lifts off. No gears, pulleys, or belts. Four heavy duty bare blocks.
- Dimensions: Drum 1 metre long, by 700 mm diameter. (3.3' x 2.3')
- Adjustable dolly wheel also for cast feed rate.
Call us toll free at (800) 237-4780 or inquire via our Contact page about these and other fine products from Our Vital Earth
|
|
